![]() ![]() Install 4 20 mm racks and fix them with the M3x8 screws. On the capture deck, install the rangefinder using self-locking nuts and M3x8 screws, and glue the radio using double-sided tape. Install the Raspberry Pi circuit board and fix with M2.5x4 bolts. Install the assembled mounting deck on the main deck and fix with the M3x8 screws. On a mounting deck, install M2.5圆 mm racks and M3x30 mm racks, fasten them with the M2.5x4 and M3x10 bolts, respectively. Install 40mm aluminum racks on the M3x10 screws. Glue 3-4 layers of double-sided tape, glue it in the center of the small deck and install Pixracer on top.Ĭonnect the speed controllers to the flight controller in accordance with the diagram.Ĭonnect the power cable to the power distribution board(PDB) and the corresponding connector on the flight controller. Place the small deck on the racks and secure it with nylon nuts. Install the damper struts, fix COEX Pix on them with nylon nuts. ![]() ![]() COEX Pixīefore installing the damper struts, screw 2 layers of nylon nuts, for a stronger fix or bite off the excess thread using side cutters. The power distribution board must be installed so that the power connection cable points toward the tail of the aircraft.Ĭonnect the power outputs of the speed controllers to the power distribution board.Ĭlover 4 drone kit allows you to install various flight controllers, for example COEX Pix and Pixracer.ĭuring installation the flight controller, pay attention to the arrow located on the board, it should be directed to the copter bow. Install the power distribution board (PDB) on the pre-mounted racks and secure it with 6mm racks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |